– 16 –
Remote control handling procedure
Replacing the batteries
The following cases signify exhausted batteries. Replace old batteries with new ones.
• Receiving beep is not emitted when a signal is transmitted.
• Indicator fades away.
• On the battery is printed its expected life. This may be shorter
than that of the air-conditioner, depending on the date of manu-
facture. However, the battery may still be in working order after
expiry of its nominal life.
• Don't use old and new batteries together.
• Remove the batteries when the remote control is not used for a
long period.
• The life of a battery conforming to J
IS or IEC should be 6 to 12
months with normal use. If used longer, or when an unspecified
battery is used, liquid may leak from the battery, causing the re-
mote control to malfunction.
Remove back lid and take out
old batteries.
Insert new batteries.
R03 (AAA, Micro) x2
Close back lid.
■ When the indicator shows any abnormal condition,
Press the reset switch with the tip of a ballpoint pen.
1
2
3
Attention to
the , and .
marks
Press the reset switch with the
tip of a ballpoint pen.
4
• Are the batteries running down?
"Replacing the batteries" above.
Replace the batteries with new ones and repeat the operation.
• Don’t drop the remote control.
Handle with care.
• Don’t go near high temperature
places, such as an electric carpet
or stove.
• Do not place heavy objects on the
remote control, or step on it.
Warning note for remote control handling
• Don’t put any obstructing obsta-
cles between the remote control
and the unit.
• Don’t spill water etc on the remote
control.
• Don’t leave the remote control ex-
posed to direct sunlight or other
strong lighting.
When the operation fails with the remote control
• If the operation still fails, handle as per emergency
run operation.
Contact your dealer.
Page 15
NOTE
RKT012A756_En.p65 10/18/06, 3:53 PM16
Black
To Next Page
Loading...
Need help?
General
