OTE
● The alarm will continue to operate for 3 minutes. At the
end of that period, the alarm will automatically shut off to
save battery power. The system will then be rearmed until
the proper disarming step is taken.
● The alarm will resume if unauthorized actions are taken
again, even if the alarm has stopped.
● While the alarm is operating, a warning is displayed on
the information screen in the multi-information display.
Type 1
Type 2
Alarm deactivation
The alarm can be deactivated in the following ways.
● By using the keyless entry system or the F.A.S.T.-key
operation to lock or unlock the doors and the liftgate.
● Except for vehicles equipped with the F.A.S.T.-key, by
turning the ignition switch to the “ON” position.
● For vehicles equipped with the F.A.S.T.-key, by putting
the operation mode in ON.
To deactivate the vehicle inclination detection function
and the interior intrusion detection function (vehicles
equipped with the interior alarm sensor)
The vehicle inclination detection function and the interior
intrusion detection function can be deactivated when parking in
automated car parks or leaving pets in the vehicle.
1. Except for vehicles equipped with the F.A.S.T.-key,
remove the key from the ignition switch.
For vehicles equipped with the F.A.S.T.-key, put the oper-
ation mode in OFF.
2. Raise and hold the wiper and washer switch to the
“MIST” position for about 3 seconds. The buzzer will
sound once and the function will be deactivated.
To activate the function again, raise and hold the wiper and
washer switch to the “MIST” position for about 3 seconds.
The buzzer will sound twice and the function will be activated.
Horn or siren sounds!
Headlights blink on and off!
BK0120400US.book 51 ページ ２０１０年５月１２日 水曜日 午前１０時５０分
To Next Page
Loading...
Need help?
General
