3-190
Features and controls
3
Headlight leveling switch
(if so equipped)
N00537100105
The direction of the headlight beam (the direction in which the
light shines) alters according to the number of people and the
load in the vehicle. Lower the headlight angle if it is too high
due to the number of people and/or the load in the vehicle so
that the headlights’ glare does not distract the drivers of
approaching vehicles. First set the light switch to the “ ”
position, then turn the headlight leveling switch knob to lower
the beam. The greater the number on the headlight leveling
switch knob, the lower the beam will point.
Set the switch to the appropriate position so that the headlight
beam is level with the road.
OTE
● Start adjusting when the knob is at the “0” position (when
the beam is at its highest).
● Keep the knob in the “0” position except when using the
knob to lower the headlight beam angle.
● Always return the knob to the “0” position when the load
is removed and the people have left the vehicle.
WARNING
!
● To avoid distraction while driving, always perform
headlight adjustments before vehicle operation.
BK0120400US.book 190 ページ ２０１０年５月１２日 水曜日 午前１０時５０分
To Next Page
Loading...
Need help?
General
