Vehicle care and maintenance
7-15
7
Brake fluid/Clutch fluid
(if so equipped)
N00938700229
The brake fluid and the clutch fluid share the reservoir tank.
To check the fluid level
The fluid level must be between the “MAX” and “MIN” marks
on the reservoir.
The fluid level is monitored by a float. When the brake fluid
level falls below the “MIN” mark, the brake fluid warning
lamp lights up.
The fluid level falls slightly with wear of the brake pads, but
this does not indicate any abnormality.
The fluid in the master cylinder should be checked when doing
other work under the engine hood. The brake system should
also be checked for leaks at the same time.
If the fluid level falls markedly in a short length of time, it indi-
cates leaks from the brake system.
If this occurs, have the vehicle checked by an authorized
Mitsubishi Motors dealer or a repair facility of your choice.
Fluid type
Use the brake fluid conforming to DOT 3 or DOT 4. The reser-
voir cap must be tightly sealed to keep dirt and water out.
CAUTION
!
● Do not let any petroleum-based fluid touch, mix
with, or get into the brake fluid. This will damage
the seals.
● Be careful when handling brake fluid. It can damage
painted surfaces.
● Use only the listed brake fluid. Different brands of
brake fluid have different additives, and these can
cause a chemical reaction. Do not mix brands of
brake fluid.
● Keep the reservoir tank cap closed to keep the brake
fluid from evaporating.
BK0115900US.book 15 ページ ２００９年１０月２７日 火曜日 午後１２時１分
To Next Page
Loading...
Need help?
General
