Mitsubishi FDC 6 Series User Manual

11
• Function of DIP switched
Switch Function
Cooling only type
Heat pump type
Remote control sensor - Enabled
Remote control sensor - Disabled
Power outage compensation - ON
Power outage compensation - OFF
ON
OFF
ON
OFF
ON
OFF
SW
1
SW 2
SW 3
• Function of Jumper wires
Switch Function
Inlet temperature display - Enabled
Inlet temperature display - Disabled
Fan display - 3 speeds
Fan display - 2 speeds
Timer function - Enabled (Normal)
Timer function - Disabled
Auto swing display - ON
Auto swing display - OFF
Wich
None
(1)
Wich
None
(1)
Wich
None
(1)
Wich
None
(1)
J1
J2
J3
J4
Note (1) 'None' means that jumper wire is not provided
on the PCB or the connection ic cut.
(b) Operation control function by the wired remote controller
(i) The following is the sequence of operation for the remote controller operation mode switch.
(ii)
CPU reset
This functions when the " inspection " and " filter reset switch " on the remote controller are pushed simultaneously. It
operates in the same manner as the power reset.
(iii)
Power outage compensation function.
¡ This is enabled by setting dip switch SW3 on the remote control circuit board to ON.
¡ It records the normally used remote control modes. Once power has been restored, it restarts operation by using the
contents of the memory. Note that the stop positions for auto swing and the timer mode are cancelled.
Parts layout on the remote controller PCB
DRY COOL FAN HEAT AUTO
Z
Y
X
R18
RED
IC3
IC4
IC5
R4
R5 R3
Q3
R7
R28
Q2
Q1
IC1
R12 R11 R13
TYPE
SW1
REMOTE
THERMO
SW2
POWEP OFF
GUARAMTY
SW3
(SW1 ~ SW4)
DIP switched
TEMP DISP.
FAN SPEED
TIMER FUNC.
SWING
DISP.
J1 J2 J3
J4
Jumper wires (J1 ~ J4)
BLACK WHITE

Mitsubishi FDC 6 Series Specifications

General

Brand	Mitsubishi
Model	FDC 6 Series
Category	Air Conditioner
Language	English