Features and controls
3-43
3
Selector lever positions
N00514200268
“P” PARK
This position locks the transaxle to prevent the vehicle from
moving. The engine can be started from the “PARK” position.
“R” REVERSE
Move the lever to this position only after the vehicle has come
to a complete stop.
“N” NEUTRAL
At this position, the transaxle is disengaged. It is the same as
the neutral position on a manual transaxle and should be used
when the vehicle is not moving for an extended length of time
during driving, such as in a traffic jam.
“D” DRIVE
This position is used for most city and highway driving. Engine
shifting and braking are done automatically as needed, depend-
ing on road conditions.
OTE
● For information on manual gate operation, please refer to
“Sports mode” on page 3-44.
CAUTION
!
● Never shift into the “P” (PARK) or “R”
(REVERSE) position while the vehicle is in motion.
If the lever is shifted into the “P” (PARK) or “R”
(REVERSE) position while the vehicle is in motion,
the transaxle may be damaged.
WARNING
!
● Never move the selector lever to the “N” (NEU-
TRAL) position while driving since you could acci-
dentally slip it into the “P” (PARK) or
“R”(REVERSE) position, damaging the transaxle.
● To prevent the vehicle from rolling when stopped on
a slope, the engine should be started in the “P”
(PARK) position, not in “N” (NEUTRAL).
● Always keep your foot on the brake pedal when the
vehicle is in “N” (NEUTRAL), or when shifting into
or out of “N” (NEUTRAL), to prevent rolling.
BK0121200US.book 43 ページ ２０１０年４月１４日 水曜日 午前１１時２４分
To Next Page
Loading...
Need help?
General
