Mitsubishi MDS-A-SVJ Series User Manual

MDS-A-SVJ
Parameter Descriptions
N.SlllCZ
svo49
svoso
svo51
SV052
svo53
svo54
svo55
SVO56
SVO57
SVO50
SW059
SVO60
SV061
SVO62
SV063
SV064
bbrevi-
ation
FGM1sp
ffiN2sp
OD3
EHCdt
EMGt
-i%E-
-EiiiK
DAlMPY
Description
Sets position loop gain during special operation, e.g., with syn-
chronous tap,
main axis C-axis interpolation.
Normally sets main axis position loop gain.
Set toaether with SVOS~:SHGCSD if SHG control is carried out during
special operation, e.g.. with synchronous tap, main axis C-axis
interpolation.
Set to zero when not in use.
Must be set to zero.
Must be set to zero.
Sets excessive error detection range for special operation. e.g.,
absolute position initial setting or at machine end stopper method.
flith a setting of zero,
excessive error detection does not take
place when the servo is ON during special operation.
Must be set to zero.
Sets time in ms from start of deceleration control to application
of dynamic braking.
Normally set to same value as SV056:EMGt.
A setting of zero is taken as an input of 2,000 ms.
Set to 1 if dynamic braking is selected without deceleration con-
trol.
Dynamic braking selection takes precedence over position loop step
stopping.
For axes with brakes,
select position loop step stopping or dynamic
braking.
This parameter's time setting must be larger than that of
SV048:EMGrt.
Sets time taken to stop from maximum rapid traversing speed (RAPID:
axis configuration parameter) following an emergency stop
(caused
by an external emergency stop input, insufficient voltage, or
alarm).
From other speeds, deceleration control takes place in direct pro-
portion to the parameter setting.
Normally set to same value as rapid traverse time constant.
A setting of zero sets position loop step stopping.
Reset NC power SUDD~Y after changing RAPID (axis configuration
parameteri.
__ _
Set together with SVOO4:PGNZ when SHG control is used.
Set to zero when not in use.
Set together with SVOSO:PGN2sp if SHG control is used during spe-
cial operation, e.g., with synchronous tap, main axis C-axis inter-
wlation.
Must be set to zero.
Must be set to zero.
Sets output data number of D/A output channel.
Must be set to zero.
Sets output amplification rate of D/A output channel.
Output amplification rate = setting value / 256.
A setting of zero is taken as a setting value of 256 (output ampli-
fication rate = 1).
Must be set to zero.
range
aximum
200
999
32767
0
0
0
5000
5ooo
999
0
7
-32768
32767
BNP-B3882B

Mitsubishi MDS-A-SVJ Series Specifications

General

Brand	Mitsubishi
Model	MDS-A-SVJ Series
Category	Controller
Language	English