Mitsubishi PEA-RP.EA User Manual

4
2
2.4. Selecting a fan speed
1 Press button to select a desired fan speed.
• Each time you press the button, available options change with the display A on
the remote controller, as shown below.
Fan speed
Remote controller display
Low High
2-stage
The display and the fan speed of the unit will differ in the following situations:
• When STAND BY and DEFROST are displayed.
• Just after the heating mode (while waiting to change to another mode).
• When the temperature of the room is higher than the temperature setting of the
unit operating in the heating mode.
• In the dry operation, the indoor fan automatically turns to low-speed operation.
Switching of fan speed is impossible.
2. Operation
TIMER SET
ON/OFF
˚C
˚C
FILTER
CHECK TEST
TEMP.
A
1
2.3. Selecting a temperature
TEMP.
ss
ss
s To decrease the room temperature:
1 Press
button to set the desired temperature.
A The selected temperature is displayed.
• Each time you press the button, the temperature value decreases by 1 °C.
ss
ss
s To increase the room temperature:
1 Press
button to set the desired temperature.
A The selected temperature is displayed.
• Each time you press the button, the temperature value increases by 1 °C.
• Available temperature ranges are as follows:
Cooling & Drying: 19 - 30 °C
Heating: 17 - 28 °C
Automatic: 19 - 28 °C
Circulation: — (Not available)
• The display flashes either 8 °C - 39 °C to inform you if the room temperture is lower
or higher than the displayed temperature.
▼
▼
TIMER SET
ON/OFF
˚C
˚C
FILTER
CHECK TEST
TEMP.
A
1
↑
ON OFF
ON OFF
TIMER SET
ON/OFF
CLOCK
˚C
˚C
FILTER
CHECK TEST
TEMP.
A
2
1
B
TIMER SET
ON/OFF
CLOCK
ON OFF
˚C
˚C
FILTER
CHECK TEST
TEMP.
1
D
B
2
3
CA
2.5. Using the timer
1) Set the current time
1 Press button to display the “CLOCK” B.
Remote CLOCK →
CLOCK
ON
→
CLOCK
OFF
→ No Display
controller display A
2 Each time you press
button, the time increases in increments of one minute.
Each time you press
button, the time decreases in increments of one minute.
• Press and hold the button to rapidly change the time.
• The time changes in increments of one minute → ten minutes → in units of hour; in
this order.
• Approximately ten seconds after pressing the button, the display on the remote
controller will turn off.
The example shows a timer set for operation start at 8:00 and end at 17:00.
2) Set the mode to continuous as follows
1 Press button to display D.
3) Set the time to start the unit as follows
2 Press button to display B
ON
.
3 Press
TIMER SET
button to set the time that you want the unit to start.
The start time is displayed at A.
4) Set the time to stop the unit as follows
2 Press button to display C
OFF
.
3 Press
TIMER SET
button to set the time that you want the unit to stop.
The stop time is displayed at A.
5) Set the mode to timer as follows
1 Press button to display D.

Mitsubishi PEA-RP.EA Specifications

General

Brand	Mitsubishi
Model	PEA-RP.EA
Category	Air Conditioner
Language	English