-
17
-
'11 • SCM-SM-110
(12) Installation location setting (SRK series only)
(Except SRK71ZK-S model)
When the indoor unit is installed at the end of a room, control the air flow direction so that it is not toward the side walls. If you
set the remote controller installation position, keep it so that the air flow is within the range shown in the following figure.
(a) Setting
1) If the air conditioning unit is running, press the ON/OFF button to stop.
The installation location setting cannot be made while the unit is running.
2) Press the AIR FLOW
(UP/DOWN) button and the
AIRFLOW
(LEFT/RIGHT) button together for 5 seconds
or more.
The installation location display illuminates.
3) Setting the air-conditioning installation location.
Press the AIR FLOW
(LEFT/RIGHT) button and adjust to the desired
location.
Each time the AIR FLOW
(LEFT/RIGHT) button is pressed, the
indicator is switched in the order of:
4) Press the ON/OFF button.
The air-conditioner's installation location is set.
Press within 60 seconds of setting the installation location (while the installation location setting display illuminates).
Airflow range Airflow range Airflow range
(Left End Installation) (Center Installation) (Right End Installation)
(13) Determining the operating mode
The cooling and heating operating modes are the remote controller mode that have been previously determined.
If a mode differing from these is selected after this, the selected mode will appear in the display of the remote controller, but
only the fan will operate.
First operation Second operation
Notes
Selected Mode
Cooling
Heating
Example
1
2
Remote Controller Display
Cooling
Heating
Operation
Cooling
Heating
Selected Mode
Heating
Cooling
Remote Controller Display
Heating
Cooling
• Different mode is
only fan operation.
Operation
Fan
(1)
Fan
To Next Page
Loading...
Need help?
General
