– 31 –
Hold the lower corners of A, then release the
hook from the main body part.
How to remove and install the air inlet panel
(3) Install
Insert the panel arm into the slot on the front panel from the position
shown on the left (Install at the same angle as when removed.).
Hold the panel at both ends of the lower part, lower it downward
slowly, and then push it slightly until it snaps into place.
• Air inlet panel’s open/close of this unit is driven by electrical motor.
• Improper handling by hand will cause mechanical damage and effect to open/close operation.
• Do not close air inlet panel forcibly.
Outer panel is to be closed automatically when power source is ON.
NOTE
Approx. 80°
Hold both panels
1. Basic structure
2. How to remove the air inlet panel
(1) Open
Lift up A together with B by holding both of
them.
Lift up A to just below level (about 80 degrees).
Hold both panels and extract them in front.
(2) Remove
B: Inner panel
of air inlet panel
: Hook
A: Outer panel of air
inlet panel
Main body
Press these parts.
RLF012A204_EN_1-36.indd 31RLF012A204_EN_1-36.indd 31 7/29/2017 6:11:40 PM7/29/2017 6:11:40 PM
To Next Page
Loading...
Need help?
General
