Mitsubishi SS series User Manual

31 / 46
Operation Manual Mitsubishi SS-Series diesel engines
Version 08/2004
MAINTENANCE
ENGLISH
6.4 Every 1000 service hours
6.4.1 Check the starter
1. Check for visual defects.
2. Check to see if the pinion is shifted into mesh
with the flywheel ring gear when the starter is
energized. If the pinion does not shift properly,
consult your Mitsubishi dealer.
6.4.2 Check the alternator
1. Check for visual defects.
2. Remove the belt from the alternator. Turn the
pulley by hand to check the alternator for
smooth rotation. If the alternator fails to rotate
smoothly, consult your Mitsubishi dealer.
6.5 Every 2 years
6.5.1 Change coolant
Long Life Coolant (LLC) used in your engine
retains its efficiency for 2 years. Be sure to change
the coolant every 2 years.
6.5.2 Draining
1. Start and operate the engine until the coolant
temperature is 70°C to 80°C (158°F to 176°F).
Then stop the engine.
2. Remove the filIer cap only after the engine
has been stopped and the cap is cool enough
to remove with your bare hands.
3. Open the radiator drain valve and remove the
engine drain plug.
4. Then allow the coolant to drain into the
containers.
6.5.3 Flushing
1. Close the radiator drain valve and install the
engine drain plug.
2. Fill the cooling system with a cleaning solution
which does not chemically attack rubber or
metal surfaces. Start and operate the engine
at 800 to 900 rpm and let the engine run for 15
minutes. Stop the engine and drain the
cleaning solution.
3. Fill the system with clean water and operate
the engine at 800 to 900 rpm for 10 minutes.
Continue to flush the system until the draining
water is clear.
6.5.4 Refilling
1. Tighten the radiator drain valve and the
engine drain plug.
2. Remove the by-pass hose (A) at the
thermostat housing.
Water drain cock

Mitsubishi SS series Specifications

General

Brand	Mitsubishi
Model	SS series
Category	Engine
Language	English