mori seiki CL-25 User Manual

P-9
PC PARAMETERS
RELATED WITH
PROGRAMMABLE
TAILSTOCK
4.
This
section deals
with
the
PC
parameters
related
with
the
programmable
tailstock.
WARNING
The
parameters
are
set
on
shipment
in
accordance
with
the
machine
specifications;
do
not
change
them without
first
consulting
Mori
Seiki.
If
the
parameters
are
changed
without
consultation,
the
machine
may
operate
in
an
unexpected
manner,
causing
accidents
involving
serious
injuries
or
damage
to
the
machine.
A
jT~y3
For
the
setting
of
the
parameter,
refer
to
page
P
-
2
(2.)
Address
Description
PCLPOK.
P
(D125.6)
1
:
Clamp
is enabled
after
Z-axis
movement
in
the
positive
direction
(manual mode)
0:
Clamp
is disabled
after
Z-axis
movement
in
the
positive
direction
(manual
mode)
Standard
setting
is
“0”.
3
TSRPD.
P
(K4.3)
1
:
Rapid
override is
25%
or
lower while
programmable
tailstock
is
unclamped.
0:
Rapid
override
is
50%
or
lower while
programmable
tailstock
is
unclamped.
Standard
setting
is
“0”.
<3
1
:
Manual
rapid
traverse
rate
is
fixed
at
[m]
(fine
feed)
while
programmable
tailstock is
unclamped.
0:
Manual
rapid
traverse rate
is
according
to
the
rapid
override while
tailstock
is
unclamped
while
programmable
tailstock
is
unclamped.
Standard
setting
is
“0”.
TSJOG.
P
(K4.1)
<3
TSOCOK.
P
(D149.2)
1
:
Unclamp
is
enabled
even
when the
programmable
tailstock
is
not at
the
tailstock connective
position.
0:
Unclamp
is
disabled
only
when the
programmable
tailstock is
at
the
tailstock
connective
position.
Standard
setting
is
“0”.
3
This
parameter
is
the
on-site
adjustment
parameter.

mori seiki CL-25 Specifications

General

Brand	mori seiki
Model	CL-25
Category	Lathe
Language	English