Remote and Standalone Antenna Configurations
To comply with EU RF exposure requirements, antennas that are mounted externally at remote locations or operating near users at
stand-alone desktop of similar configurations must operate with a minimum separation distance of 20 cm from all persons.
US and Canada
Co-located statement
To comply with FCC requirements, the antenna used for this transmitter must not be co-located or operating in conjunction with any
other transmitter/antenna except those already approved in this filling.
To satisfy US and Canadian RF exposure requirements, a transmitting device must operate with a minimum separation distance of 20
cm or more from a person’s body.
Pour satisfaire aux exigences Américaines et Canadiennes d'exposition aux radiofréquences, un dispositif de transmission doit
fonctionner avec une distance de séparation minimale de 20 cm ou plus de corps d'une personne.
Power Supply
CCHUB1 Power Supply
Use ONLY a LISTED Motorola, Type no. PWRS-14000 (12Vdc, 4.16A),direct plug-in power supply, marked Class 2 or LPS (IEC60950-
1, SELV). Use of alternative Power Supply will invalidate any approvals given to this unit and may be dangerous.
Radio Frequency Interference Requirements - FCC
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
To Next Page
Loading...
Need help?
General