10
English
GETTING STARTED
Charging the Battery
Refer to picture below for the battery insert visual guide line.
1. Make sure the radio is OFF.
2. Plug the power supply into an electric outlet.
3. Connect the power supply output cord connector into
the rear of the Desktop Charging Tray.
4. The LED on the charger blinks green once to indicate
charger is turned ON.
CP185
5. Turn the radio OFF before charging the battery. Insert
a battery, or a radio with a battery into the charger’s
pocket by:
aligning the groove on each side of the battery
with the corresponding raised rail on each side of
the charger pocket
OR
pressing the battery towards the rear of the
pocket
OR
sliding the battery into the charger pocket,
ensuring complete contact between the charger
and battery contacts.
6. The charger’s LED color will indicate the battery
charging status. (See “Charging Status” on page 11).
Battery insert visual guide line
Battery Charging Tray
Beacon LKP NALA.book Page 10 Wednesday, February 25, 2009 5:34 PM
To Next Page
Loading...
Need help?
General