5
English
Charging Instructions
1. Make sure the radio is Off.
2. Plug the power supply into an electric outlet.
3. Connect the power supply output cord connector into the rear
of the Desktop Charging Tray.
4. The LED on the charger blinks green once to indicate charger
is turned on.
5. Insert the radio into the pocket of the Desktop Charging Tray.
If the battery is being charged separately, insert the battery
into the back pocket of the Desktop Charging Tray.
6. The charger’s LED color will indicate the battery charging
status. (See table below).
LED Color Charging Status
Solid Red Charging
Blinking Red Battery Fault
Solid Green Charge Complete
Blinking Green Top-off Charging
Single Blink Green Power On
Blinking Yellow Waiting to Charge
6871916T01.book Page 5 Tuesday, March 8, 2016 9:48 AM
To Next Page
Loading...
Need help?
General