31
PROGRAMMABLE FEATURES
repeatedly if cloning failed..
8. Once the cloning process is completed, turn the
Radios OFF and ON again to exit “Clone”
mode.
What To Do If Cloning Fails
Radio LED Indicator shows a sequence of one
green blink, one orange blink, one green blink
repeatedly if cloning failed. In the event that the
cloning fails, perform each of the following
steps before attempting to start cloning process
again:
1. Ensure that the batteries on both radios are fully
charged.
2. Check the cloning cable connection on both
SUCs.
3. Ensure that the battery is engaged properly on
the radio.
4. Ensure that there is no debris in the charging
tray or on the radio contacts.
5. Ensure that the Target radio is turned ON.
6. Ensure that the Source radio is in cloning mode.
7. Ensure that the two radios are both from the
same frequency band, same region and have
the same transmission power.
Note: This cloning cable is designed to operate
only with compatible Motorola Solutions
SUC.
When ordering Cloning Cable, please refer to
P/N# HKKN4028_. For more information about
the accessories, refer to “Accessories” on
page 44.
To Next Page
Loading...
Need help?
General
