Mpow Streambot 2-In-1 User Manual

2. The light indicator will turn into red when charging.
3. The full charge takes about 2 hours.
4. The red light indicator goes out when charging completed.
Power on/off:
1. Power on: Press Multi-function button for 6 seconds, And the LED indicator will
turn blue for 1 second.
2. Power off: Press Multi-function button for 4 seconds, And the LED indicator will
turn Red for 1 second and then off.
TX Mode: To use as a Bluetooth transmitter
Selecting mode: please slide the switch into TX before power on Mpow Streambot
2-In-1.
Note:
Selecting mode must be done before power on.
TX or RX mode cannot be changed after power on.
Pairing with a Bluetooth device
1. Before pairing , please make sure the Mpow Streambot 2-In-1 is in TX Mode and
within 1 meter to your Bluetooth device
2. Press and hold Multi-function button of the Mpow Streambot 2-In-1 for 9 seconds
until the LED indicator light flashes blue quickly.
3. The transmitter will search for Bluetooth stereo receiver and connect with it
automatically. LED indicator will flash blue twice every 4 seconds after
connected.
4. Connect the transmitter to your music player through 3.5mm audio jack to play
music.
Note:
1. The pairing mode will last around 2 minutes. It will turn to standby mode if
there is no device can be connected within 2 minutes.
2. The transmitter can only pair with one Bluetooth device.
3. The transmitter will automatically connect to the last connected device after turn
on.
4. The transmitter will automatically power off if no devices connected within 5
minutes.

Mpow Streambot 2-In-1 Specifications

General

Brand	Mpow
Model	Streambot 2-In-1
Category	Receiver
Language	English