Mpow Streambot 2-In-1 User Manual

Clearing pairing list
Make sure the transmitter is off，press and hold Multi-function button for about 16
seconds until LED indicator flashes red and blue for one second then release it to
clear the pairing list.
RX Mode: To use as a Bluetooth receiver
Selecting mode: please slide the switch into RX before powering on Mpow Streambot
2-In-1.
Note:
Selecting mode must be done before power on.
TX or RX mode cannot be changed after power on.
Pairing with Bluetooth devices
1. Before pairing, please make sure the Mpow Streambot 2-In-1 is in RX Mode and
within 1 meter to your cell phone.
2. Press and hold MFB for 9 seconds until the LED indicator flashes blue and red
alternately, the receiver is in pairing mode.
3. Turn on the Bluetooth function of your cell phone and Search for the Bluetooth
devices and select "MPOW 2 in 1". (Enter the code "0000" if needed.)
4. LED indicator of receiver will flash blue twice every 4 seconds after connected.
Note:
1. The pairing mode will last around 2 minutes. It will turn to standby mode if
there is no device can be connected within 2 minutes.
2. The receiver can only pair with one Bluetooth device.
3. The receiver will automatically connect to the last connected device after turn on.
4. The receiver will automatically power off if no devices connected with the unit
within 5 minutes.
Clearing pairing list
Make sure the receiver is off, press and hold multi-function button for about 16
seconds, until LED indicator flashes red and blue for one second then release to clear
the pairing list.

Mpow Streambot 2-In-1 Specifications

General

Brand	Mpow
Model	Streambot 2-In-1
Category	Receiver
Language	English