Page 13
Operating Instructions
mrcool.com
FilterTab
CAUTION
Power supply must be disconnected before attempting
to clean or service. Failure to do so can cause electrical
shock.
DO NOT use benzene, thinner, polishing powder, or
similar solvents for cleaning. These may cause the
plastic to crack and/or deform.
DO NOT clean the unit with excessive amounts of water.
DO NOT touch the metal parts of the unit when
removing the filter. Injuries can occur when
handling the sharp metal edges.
DO NOT use water to clean inside the air
conditioner. Exposure to water can destroy the
insulation, leading to possible electric shock.
DO NOT use a chemically treated cloth or duster to
clean the unit.
DO NOT touch air freshening (Plasma) filter for at least
10 minutes after turning off the unit.
DO NOT clean the unit with combustible cleaning
agents. These could cause fire or defomation.
DO NOT wash air filter with water hotter than 40°C /
104°F.
DO NOT expose the filter directly to the sun, it may
shrink. Dry it in the shade.
Before performing maintenance, turn the power off to
the unit. Then, disconnect the power to the circuit at the
breaker.
Cleaning the Unit:
Wipe the unit with a soft dry cloth. If the unit is very dirty, wipe it
with a cloth soaked in warm water. DO NOT use bleach or abrasives.
Cleaning the Air Filter and Air Freshener:
A clogged air filter can greatly reduce the heating and cooling
efficiency of this unit. It is recommended to clean the unit every 2
weeks.
1. Open the front panel by carefully lifting both ends at the same
time. At a certain angle, there will be an audible click and the lid
becomes self-supporting. For some models, suspension bars are
provided and required to prop up the lid.
2. Use the filter tabs to lift the filter slightly upward and then toward
you.
1
2
3
Care and Maintenance
To Next Page
Loading...
Need help?
General
