4
Getting Started
Installing the Monitor Stand
⚠
Important
∙
Remove the screws on the monitor groove if needed before installing the stand.
∙
Place the monitor on a soft, protected surface to avoid scratching the display panel.
G2412 / G2712
1. Leave the monitor in its protective foam packaging. Align the stand bracket to the
monitor groove. Tighten the stand bracket with screws.
2. Connect the base to the stand and tighten the base screw to secure the base.
3. Align and push the stand cover towards the monitor groove until it locks in place.
4. Make sure the stand assembly is properly installed before setting the monitor
upright.
2
3
1
2
3
To Next Page
Loading...
Need help?
General