3-9
BIOS Setup
▍
MS-7578
advanced bioS featureS
BIOS Flash Protecton
Ths functon protects the BIOS from accdental corrupton by unauthorzed users or
computer vruses. When enabled, the BIOS?data cannot be changed when attemptng
to update the BIOS wth a Flash utlty. To successfully update the BIOS, you wll need to
dsable ths Flash BIOS Protecton functon. You should enable ths functon at all tmes.
The only tme when you need to dsable t s when you want to update the BIOS. After
updatng the BIOS, you should mmedately re-enable t to protect t aganst vruses.
Full Screen Logo Dsplay
Ths tem enables ths system to show the company logo on the boot-up screen. Set
-
tngs are:
[Enabled] Shows a stll mage (logo) on the full screen at boot.
[Dsabled] Shows the POST messages at boot.
Quck Bootng
Settng the tem to [Enabled] allows the system to boot wthn 10 seconds snce t wll
skp some check tems.
Boot Up Num-Lock LED
Ths settng s to set the Num Lock status when the system s powered on. Settng to
[On] wll turn on the Num Lock key when the system s powered on. Settng to [O] wll
allow users to use the arrow keys on the numerc keypad.
IOAPIC Functon
Ths eld s used to enable or dsable the APIC (Advanced Programmable Interrupt
Controller). Due to complance wth PC2001 desgn gude, the system s able to run n
APIC mode. Enablng APIC mode wll expand avalable IRQ resources for the system.
▶
▶
▶
▶
▶
To Next Page
Loading...
Need help?
General
