mspa D-NE02 Nest User Manual

12
SPA SET-UP
Move the entire package to the selected site. Open the carton carefully as it can be used to store the spa
during long term storage or when not in use.
Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tub is
right side up. (*For missing or damaged part, contact the MSpa Service Center)
1.
2.
1 2
D-NE02: For this model, a side bar is included in
the package. Set up the wicker bar and place the
supporting legs underneath the spa tub before
filling the water. It helps keeping the oval spa in a
proper shape after water filling and inflation.
●
D-AL04/06, D-TE06, D-
LA06: Spread out the
square ground mat and
place it to the selected site.
Make sure the buckle of
cover and mat is attached
when spa not in use.
●
NOTE:
this side
face down
Spa Inflation
3.1 Plug the spa into the grounded supply socket.
3.2 Press RESET button on the PRCD, the screen on controller shows numbers.
3.3 Turn the inflation knob to the inflating status <ON> and press the bubble button on the controller to
start inflating. After manometer shows green, the inflation is complete.
3.4 Turn the knob back <OFF> and press BUBBLE button again to stop.
3.
3.3
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
°C
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
°C
BUBBLE
green
ON

mspa D-NE02 Nest Specifications

General

Brand	mspa
Model	D-NE02 Nest
Category	Hot Tub
Language	English