Page - 1
www.multispanindia.com
Front Key:
OPERATING MANUAL
LC - 3006
A) Display : 6 Digit display in RED colour indicating current reading of TOTAL METER
During Running mode and MTRS/MIN when shift key is pressed.
These front keys can be used to see and change the current value of
A) Total Meters SET Point (SET) : Set point value is automatically compared with current
Value of Total Meters. A relay is switched ON when set value and total meter are equal. This
Relay output can be used to start or stop machine.
Maximum Range : 99999.9
B) Diameter OF Roller (D): It is the diameter of roller over which the material (thread)
Passesd. MAXIMUM RANGE : 999.99 mm
C) Auto Reset Time (T): It is the auto reset time of relay remains in ON condition.
MAXIMUM RANGE : 99.9 Seconds.
B) LED’S : Three Red LED indicates following status when it glows :
Relay-1 : Relay Operates when total meters are reached.
L : Gives only indication when the total length in meter is seen during running Mode.
S : Gives only indication when the speed in MTRS/MIN is seen during running mode by
Pressing shift key.
44 X 92 mm
230V AC,50Hz,Approx 4VA
Model
Panel Cutout
Dimension
Display
Output
Input
Operating Ambient
Temperature
Supply
Reset
Relative Humidity
48 X 96 X 120 mm
Single Display: 6 digit, 0.4’’,
1 Relay 1C/O, 230V AC, 5A
7 segment, Red LED
LC - 3006
NPN/PNP Proximity Switch
0°C - 55°C
Reset at back terminal
Up to 95 % RH Non Condensing
SET
ENT
RESET
LC-3006
LC 3006
9 9 9 9 9. 9
Technical Specification
Displays
To Next Page
Need help?
General
