30
CHECKING CODE-LIBRARY NUMBER
You can check the current code-library on any Device Selector key as follows. Enter Library Mode by
simultaneously pressing-and-holding for 3 seconds both the desired component’s Device Selector key and
the “PROGRAM” key, until the Learn LED turns green. Press the “DISP” key; the HTR L70 indicates the
current code-library by flashing its “TAPE”, “VCR”, and “MACRO” keys. For example, to indicate code-
library #501 the HTR L70 will flash “TAPE” 5 times, pause, and then flash “MACRO” once. You might
wish to make a note of your components’ code-library numbers.
SUMMARY OF HTR L70 MODES
Mode Keys To Press (for 3 seconds)
Learn/Copy/Punch Through Device Key + OPEN/CLOSE Key
Delete Mode Device Key + Return Key
Macro Record Macro Key + Function Key
Library Mode Device Key + Program Key
Back Light Timeout Display Key + Digit Key
Factory Reset (see “Factory Reset,” above)
USING THE HTR L70 REMOTE CONTROL
Operation
ENGLISH FRANÇAIS
DEUTSCH
NEDERLANDS
ESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
To Next Page
Loading...
Need help?
General
