NAD T 787 User Manual (English)

To Next Page

To Previous Page

A/V PRESETS

The T 787’s simple but powerfully exible system of “A/V Presets” allows

you to customize virtually every aspect of your audio-video playback, and

recall them with a single key-press. The parameters “Listening Mode”, “DSP

Options” and “Tone Controls” accessible via the “Main Menu” together with

“Speaker Setup” and “Display Setup” congurable through “Setup Menu” are

stored together as a single A/V Preset.

You might create one A/V Preset optimized for pop music and another for

classical. One more A/V Preset can be set up to recall each family member’s

favorite setting or one for fully cinematic home-theater playback and yet

another one for late-night movies, with each A/V Preset ne-tuned to a

particular scenario or preference.

CREATING PRESETS

Creating an A/V Preset consists simply of storing a complete set of the

parameters set forth in “Listening Mode”, “DSP Options” and “Tone Controls”

accessible via the “Main Menu” together with “Speaker Setup” and “Display

Setup” congurable through “Setup Menu”.

Scroll to “A/V Presets” using the [ D/F ] keys to save a collection of said

parameter settings to a Preset. Select a Preset number and by pressing the

[ D/F ] keys, you can selectively include in the particular A/V Preset any of

the above-mentioned parameter settings by choosing “Yes”. If you decide

not to include in the particular A/V Preset a certain parameter setting, select

“No”.

Now in order to save the settings chosen for the particular A/V Preset

number, scroll down to “Save Current Setup to Preset” and press the [ S ]

key. If you chose to load instead the default settings, scroll down to “Load

Defaults to Preset” and press the [ S ] key to restore the default settings.

In addition to the parameter settings, the A/V Preset label itself can be

assigned a new name. This new Name will be shown in the VFD as well as

on the OSD.

To rename the A/V Preset label, scroll to “Name” and press [ S ] to go the rst

character. Then, press [ D/F ] to pick and select through the alphanumeric

selections. Press [ A/S ] to move to the next character or back to the

previous character and at the same time save the changes done on the

current character.

NOTE

 TheselectedA/VPresetremainsinforceuntilyouselectadierentA/V

Preset.

SAMPLE PROCEDURE FOR SETTING UP A/V PRESETS

1 Setup rst your preferred settings for the following options (access

them through their respective menu page).

Listening Mode: Stereo

DSP Options: 5ms

Tone Controls: Tone Defeat: On

Display Setup: Set “Line 2” to “Listening Mode”

OPERATION

USING THE T 787  SETUP MENU

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

Need help?

Do you have a question about the NAD T 787 and is the answer not in the manual?

NAD T 787 Specifications

General

Frequency Response	20Hz-20kHz
Signal to Noise Ratio	> 100 dB
HDMI Outputs	2
Audio Decoding	Dolby TrueHD, DTS-HD Master Audio
Multi-Room Zones	2
Input Sensitivity	200 mV
Power Output (8 Ohms)	120 W
Power Output (4 Ohms)	200 W
Outputs	2 x HDMI, Component Video, Composite Video, Coaxial Digital, Optical Digital
Video Processing	Yes
Video Upscaling	Yes