NAPCO EXPRESS Series Using Instruction

13
9
System Troubles
Keypad Beeps or
9
9
SYSTEM
Flashes
Zone light
ON
System Trouble
Condition
Action
2 Beeps 1 Bell / Siren Trouble There is a problem with the Bell or Siren. Call installing com-
pany for service.
2
Beeps
3 Wireless Receiver
Trouble
A problem has been detected with the wireless receiver.
Call installing company for service.
2
Beeps
4 Wireless Receiver
Jam
A problem has been detected with a wireless receiver.
Call installing company for service.
3
Beeps
1-4 Wireless
Transmitter Low
Battery
The battery in a wireless transmitter is low and should be re-
placed. This transmitter is on the zone corresponding to the
number of the lit zone light. The replacement battery for the
GEM-Trans2 door/window transmitter, GEM-PIR motion de-
tector and GEM-GB glass break detector is the Duracell
DL123A. (2 required for the GEM-PIR and GEM-GB.) The
GEM-DT Dual Technology Sensor requires 4 C-Cell Duracell
MN1400 Alkaline batteries.
Warning: Replace batteries only with the same type as speci-
fied above. Use of another battery may present a risk of fire or
explosion. Do not recharge or disassemble battery, or dispose
of in fire.
4
Beeps
1-4 Wireless
Transmitter
Supervisory Failure
A problem has been detected with a wireless transmitter.
Call installing company for service
7
Beeps
1-4 Zone Trouble Call installing company for service.
SYSTEM
READY
ZONE 3
ZONE 1
ZONE 2
ZONE 4
ARMED
Oi220a
page 13
Tuesday, September 16, 1997 08:30

NAPCO EXPRESS Series Specifications

General

Brand	NAPCO
Model	EXPRESS Series
Category	Security System
Language	English