CALIBRATION PROCEDURE
NI USB-TC01
This document contains information for calibrating the National
Instruments USB-TC01. For more information about calibration,
visit
ni.com/calibration.
Contents
Conventions ............................................................................................ 1
Documentation Requirements................................................................. 2
Test Equipment ....................................................................................... 2
Test Conditions ....................................................................................... 2
Calibration Procedures............................................................................ 3
Initial Setup...................................................................................... 3
Verification ...................................................................................... 3
Verifying Temperature Measurement Accuracy ...................... 3
Where to Go for Support......................................................................... 4
Conventions
The following conventions are used in this document:
» The » symbol leads you through nested menu items and dialog box options
to a final action. The sequence File»Page Setup»Options directs you to
pull down the File menu, select the Page Setup item, and select Options
from the last dialog box.
This icon denotes a note, which alerts you to important information.
bold Bold text denotes items that you must select or click in the software, such as
menu items and dialog box options. Bold text also denotes parameter names.
italic Italic text denotes variables, emphasis, a cross-reference, or an introduction
to a key concept. Italic text also denotes text that is a placeholder for a word
or value that you must supply.
monospace Text in this font denotes text or characters that you should enter from the
keyboard, sections of code, programming examples, and syntax examples.
This font is also used for the proper names of disk drives, paths, directories,
programs, subprograms, subroutines, device names, functions, operations,
variables, filenames, and extensions.
To Next Page
Need help?
General
