6
Quick Start –continued
Removing the Base
Note: Always remove the Base when shipping the LCD.
1.
Place monitor face down on a non-abrasive
surface.
2. While using your thumbs, press the tabs in the
direction of the arrows to unlock the stand.
3. Pull the unlocked base off the stand.
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm. Please use the attached
screws (4pcs) as shown in the picture when installing.
To meet the safety requirements, the monitor must be mounted to an arm which
guaranties the necessary stability under consideration of the weight of the monitor.
The LCD monitor should only be used with an approved arm (e.g. GS mark).
Replace screws
Specifications
If using other screws,
check depth of holes.
4-SCREWS (M4)
Tighten all
screws.
Thickness of
Bracket (Arm)
2.0~3.2 mm
(MAX depth: 8.5 mm)
75 mm (LCD52V)
100 mm (LCD72V)
100 mm (LCD92V)
75 mm (LCD52V)
100 mm (LCD72V)
100 mm (LCD92V)
Weight of LCD assembly:
2.8 kg - LCD52V (MAX)
4.2 kg -LCD72V (MAX)
5.5 kg - LCD92V (MAX)
AS52V72V92VManual080404.p65 8/5/04, 7:45 PM6
To Next Page
Loading...
Need help?
General