English-18
Color
Color Control System: Color presets are available for adjusting color settings. (sRGB and NATIVE color presets are
standard and cannot be changed).
1, 2, 3, sRGB, 5: Increases or decreases Red, Green or Blue color depending upon which is selected. The change
in color will appear on screen and the direction (increase or decrease) will be shown by the bars. sRGB mode
dramatically improves the color fidelity in the desktop environment by a single standard RGB color space. With this
color-supported environment, the operator could easily and confidently communicate color without further color
management overhead in most common situations.
NATIVE: Original color presented by the LCD panel that is unadjustable.
L/B (LOWBLUELIGHT): Reduces blue light emitted from monitor.
NOTE: You can directly change to L/B (LOW BLUE LIGHT) mode by touching the SELECT key for 3 seconds or
more. For changing to other settings from L/B mode, touch the INPUT key to show OSD menu and enter
COLOR control.
When L/B is selected in COLOR control, CONTRAST and DV MODE are disabled.
DICOM SIM.: The white point color temperature and the gamma curve are set to a DICOM simulation.
PROGRAMMABLE: The gamma curve is adjustable through application software.
NOTE: When MOVIE, GAMING, or PHOTO is selected as the DV MODE, NATIVE is selected automatically and
cannot be changed.
Tools
VOLUME
Controls the volume of the speakers or headphones.
To mute the speaker output, touch the “ECO/RESET” key.
SOUNDINPUT(HDMI,DisplayPortinputsonly)
This function selects Audio Input, HDMI or DisplayPort.
VIDEO DETECT
Selects the method of video detection when more than one video inputs are connected.
FIRST: When current video input signal is not present, then the monitor searches for a video signal from the other
video input ports. If the video signal is present in another port, then the monitor switches the video source input port
to the new found video source automatically. The monitor will not look for other video signals while the current video
source is present.
NONE: The monitor will not search the other video input port unless it is turned on.
DP OUT MULTISTREAM
Selects DisplayPort mode.
CLONE: Sets SST (single-stream transport). Default is “CLONE”.
If multiple monitors are set to MST (multi-stream transport), same image is displayed at each monitor.
AUTO: Displays in SST (single-stream transport) or MST (multi-stream transport) mode. “AUTO” should be selected
when using MST (multi-stream transport).*
If multiple monitors are set to SST (single-stream transport), individual image is displayed at each monitor.
NOTE: When the monitor has no image, refer to Multiple monitors connection using DisplayPort (see page 12).
*: MST (multi-stream transport) and SST (single-stream transport) require the corresponding display card. Contact your dealer for limitations of this function.
RESPONSE IMPROVE
Turns the Response Improve function on or off. Response Improve may reduce blurring that occurs in some moving
images.
OFF TIMER
Monitor will automatically power down when you have selected a pre-determined amount of time.
Before powering off, a message will appear on the screen asking if you want to delay the turn off time by 60 minutes.
Touch any OSD key to delay the power-down time.
To Next Page
Loading...
Need help?
General