English-8
Remove Monitor Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest position.
3. Place monitor face down on a non-abrasive surface (Figure S.1).
NOTE: Handle with care when monitor facing down, to avoid damage to the front
control keys.
4. Place one hand around the stand and one hand on the Quick Release
Button. Push the Quick Release Button in the direction indicated by the
arrows (Figure S.1).
5. Lift up the stand to unlatch the upper hook and remove the stand
(Figure S.1).
6. The monitor is now ready for mounting in an alternate manner.
7. Connect the cables to the back of the monitor.
Screen Rotation
Before rotating, the screen must be raised to the highest level to avoid running into the desk or pinching your fingers.
To raise the screen, with one hand, grip the top of the display by the handle using the other hand to grip the bottom. Lift up to
the highest position (Figure RL.1).
To rotate screen, place hands on each side of the monitor screen and turn clockwise from Landscape to Portrait or counter-
clockwise from Portrait to Landscape (Figure R.1).
Figure R.1
Tilt and Swivel
Grasp both sides of the monitor screen with your hands and adjust the tilt and swivel as desired (Figure TS.1).
NOTE: Handle with care when tilting the monitor screen.
Figure TS.1
Figure S.1
To Next Page
Loading...
Need help?
General