English
English-13
Specifications for LCD1970NX
Monitor Specifications MultiSync LCD1970NX Monitor Notes
LCD Module Diagonal: 48.2 cm/19.0 inches Active matrix; thin film transistor (TFT)
Viewable Image Size: 48.2 cm/19.0 inches liquid crystal display (LCD); 0.294 mm dot
Native Resolution (Pixel Count): 1280 x 1024 pitch; 250 cd/m
2
*
3
white luminance;
800:1 contrast ratio, typical.
Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVI
Sync: Separate sync.TTL Level
Horizontal sync. Positive/Negative
Vertical sync. Positive/Negative
Composite sync. Positive/Negative*
2
Sync on Green (Video 0.7 Vp-p and Sync. 0.3 Vp-p)*
2
Display Colours 16,777,216 Depends on display card used.
Synchronization Range Horizontal: 31.5 kHz to 81.1 kHz (Analog) Automatically
31.5 kHz to 81.1 kHz (Digital) Automatically
Vertical: 56.0 Hz to 75.0 Hz Automatically
Viewing Angle Left/Right: 88°/88° (CR > 10)
Up/Down: 88°/88° (CR > 10)
Resolutions Supported 720 x 400*
1
: VGA-Text Some systems may not support all modes
640 x 480*
1
at 60 Hz to 75 Hz listed.
800 x 600*
1
at 56 Hz to 75 Hz
832 x 624*
1
at 75 Hz
1024 x 768*
1
at 60 Hz to 75 Hz
1152 x 870*
1
at 75 Hz
1280 x 1024 at 60 Hz to 75 Hz....................NEC DISPLAY SOLUTIONS cites
recommended resolution at 60 Hz for
optimal display performance.
Active Display Area Horizontal: 376.3 mm/14.8 inches
Vertical: 301.1 mm/11.9 inches
Power Supply AC 100-240V ~ 50/60Hz
Power Consumption 38W (typ)
(without optional Sound Bar)
Current Rating 1.2-0.6A
Dimensions 412.5 mm (W) x 386.5-496.5 mm (H) x 220.0 mm (D)
16.2 inches (W) x 15.2-19.5 inches (H) x 8.7 inches (D)
Weight Net: 8.1 kg (17.9 lbs)
Gross: 10.4 kg (22.9 lbs)
Environmental Considerations
Operating Temperature: 5°C to 35°C/41°F to 95°F
Humidity: 30% to 80%
Feet: 0 to 10,000 Feet
Storage Temperature: -10°C to 60°C/14°F to 140°F
Humidity: 10% to 85%
Feet: 0 to 40,000 Feet
*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is
normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on
the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
*2 If your display is not showing a picture of the SOG and Composite Sync. Signal, please contact our hotline for further assistance.
*3 LCD Module at 25°C.
NOTE: Technical specifications are subject to change without notice.
To Next Page
Loading...
Need help?
General