16
Monitor MultiSync
®
LCD2070NX Notes
Specifications Monitor
LCD Module Diagonal : 20.1 inch Active matrix; thin film transistor (TFT)
Viewable Image Size : 20.1 inch liquid crystal display (LCD); 0.255 mm dot
Native Resolution (Pixel Count) : 1600 x1200 pitch; 250cd/m
2
white luminence;
700:1 contrast ratio, typical
Input Signal Video : ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVI-D
Sync : Separate sync. TTL Level Positive/Negative
Composite sync. Positive/Negative
Composite Sync on Green (0.3Vp-p negative and 0.7Vp-p positive)
Display Colors 16,777,216 Dependent on display card used.
Maximum Left/Right : 88°/88° (CR>10)
Viewing Angles Up/Down : 88°/88° (CR>10)
Synchronization Horizontal : 31.5 kHz to 91.1 kHz Automatically
Range Vertical : 56.0 Hz to 85.0 Hz Automatically
Resolutions Supported 720 x 400*
1
:VGA text
Some systems may not support all modes listed.
640 x 480*
1
@ 60 Hz to 85 Hz
800 x 600*
1
@ 56 Hz to 85 Hz
832 x 624*
1
@ 75 Hz
1024 x 768*
1
@ 60 Hz to 85 Hz
1152 x 864*
1
@ 75 Hz
1152 x 870*
1
@ 75 Hz
1280 x 960 @*
1
@ 75 Hz
1280 x 1024*
1
@ 60 Hz to 85 H
z
1
600 x 1200 @ 60 Hz.......................NEC DISPLAY SOLUTIONS cites
recommended resolution at 60 Hz
for optimal display performance.
Active Display Area Horizontal : 408 mm/16.1 inches
Vertical : 306 mm/12.0 inches
USB Hub I/P: USB Specification Revision 2.0
Port: Upstream 1
Downstream 4
Load Current: Maximum 0.5A per port
Power Supply 100 – 240 V~ 50/60 Hz
Current Rating 1.25 - 0.70 A
Dimensions 442 mm (W) x 388.5-498.5 mm (H) x 220.0 mm (D)
17.4 inches (W) x 15.3-19.6 inches (H) x 8.7 inches (D)
Weight 8.6 kg
19.0 lbs
Environmental Considerations
Operating Temperature : 5°C to 35°C/41°F to 95°F
Humidity : 30% to 80%
Feet : 0 to 12,000 Feet
Storage Temperature : -10°C to 60°C/14°F to 140°F
Humidity : 10% to 85%
Feet : 0 to 40,000 Feet
*
1
Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is
normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each
dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
NOTE: Technical specifications are subject to change without notice.
Specifications
LCD2x70NXmanual070605.pmd 7/12/05, 3:30 PM16
To Next Page
Loading...
Need help?
General