To Next Page

To Previous Page

English-7

English

5. Prevent Tipping

When using the display with the optional table top stand

fasten the LCD to a wall using a cord or chain that can

support the weight of the monitor in order to prevent the

monitor from falling. Fasten the cord or chain to the monitor

using the provided clamps and screws.

For the X464UN/X464UNS/X464UNV, the clamps and

screws are included with the optional table top stand.

Screw (M4)

Cord or chain

Clamp

100 mm*

Screw Holes*

640 mm*

*: X554UN/X554UNS/X554UNV

: X464UN/X464UNS/X464UNV

Before attaching the LCD monitor to the wall, make sure that

the wall can support the weight of the monitor.

Be sure to remove the cord or chain from the wall before

moving the LCD.

X464UNS, X554UNS and X554UNV only:

Installing Optional Sensor Unit

Fixed by screw: Remove the seal, which is pasted on the

bezel you want to set, and then secure the sensor unit using

the attached screw.

Fixed by double-sided tape: You can set the sensor unit at

any side of the monitor.

NOTE: When installing the sensor on the upper and left

sides of the monitor, follow instructions below to

avoid damage to the monitor.

Installing on the upper and left side of the monitor.

Fixed by screw: Set the sensor unit close to the back side.

Fixed by double-sided tape: Set the sensor unit keeping it

8 mm away from the front edge.

Screw Position

Seal

8 mm

Double-sided tape

Questions and Answers:

Need help?

Do you have a question about the NEC MultiSync X464UN and is the answer not in the manual?

NEC MultiSync X464UN Specifications

General