To Next Page

To Previous Page

5 Mounting

This chapter is intended for installers

5.1 Choosing a mounting location

This section provides guidelines to help you select the best mounting location,

suggestions to ensure optimum performance, cautions and warnings that you

should follow in order to avoid injury and/or equipment damage, plus step-by-step

instructions for mounting a PowerRouter unit.

This section contains:

1. Choosing a mounting location

2. Dimensions and recommended clearances

3. Mounting procedure

Occasionally, the rating label on the PowerRouter will need to be referred

to. For this reason, the PowerRouter must be mounted so that the rating

label on the bottom of the unit is visible after installation.

The PowerRouter weights 15.2 kg. To avoid injury, ensure the use of

proper lifting techniques and secure the help of a second person to assist

with mounting of the unit.

Figure 4 Location of the rating label on

the bottom of the unit

label

Take account of the following guidelines, cautions, and warnings when choosing a

mounting location for the PowerRouter:

• Do not install the PowerRouter in direct sunlight. External heating from exposure to

the sun may cause excessive internal heating. This may result in output power being

reduced in order to protect the internal components from damage.

• Install the PowerRouter in a location that maintains an ambient air temperature that

is less than 40 °C. To maintain a safe internal component temperature, the

PowerRouter may reduce power if the ambient air temperature exceeds 40 °C. (The

cooler the air temperature, the longer the life expectancy of any power electronics

device.)

• The PowerRouter is designed for indoor installations. (IP21)

• The PowerRouter should be installed in a location that is inaccessible to children.

• The PowerRouter emits a slight vibrating noise when operating. This vibration is

normal and has no effect on performance but it can be disturbing if the unit is

mounted on a wall in a living area, on the outside of a wall that is near a living area,

or on certain types of materials, such as thin wood panelling or sheet metal.

caution

Nedap PowerRouter PR50S User Manual

Other manuals for Nedap PowerRouter PR50S