en Appliance door
28
4. Open the appliance door slightly until you hear a
quiet click. Close the appliance door.
:Warning
Risk of injury if the door locks are not closed!
The appliance door may become detached. You
may be injured and the appliance door damaged.
After refitting the door, always close the left- and
right-hand door locks.
5. Close the left- and right-hand door locks (fig. %).
To do this, hold the screwdriver horizontally and use
it to push the door lock on each side of the door all
the way down (fig. &).
Removing and installing the door panels
For cleaning, you can remove the glass panels from the
appliance door.
To do this, the appliance door must be removed
beforehand (see section "Removing and fitting the
appliance door").
:Warning – Risk of injury!
The appliance must not be used again until the door
panels and appliance door have been correctly fitted.
:Warning – Risk of injury!
Components inside the appliance door may have sharp
edges. Wear protective gloves.
Removal
Note: Lay the removed glass panels on an even, soft
and clean surface.
1. Remove the appliance door.
2. Lay the appliance door with the front side facing
down on an even, soft and clean surface.
3. Push on the left- and right-hand side on the outside
of the appliance door until the inner glass is
released on both sides (Fig. !).
4. Carefully lift the inner glass and remove it in the
direction of the arrow (Fig. ").
5. Push the intermediate panel downwards in the ‚
area, carefully lift the ƒ holder until it can be pulled
out (Fig. #).
6. Lift the intermediate panel from below (Fig. $) and
remove it.
7. Clean all panels on both sides with glass cleaner
and a soft cloth.
:Warning
Risk of injury!
Scratched glass in the appliance door may develop
into a crack. Do not use a glass scraper, or sharp or
abrasive cleaning aids or detergents.
8. Dry and refit all panels.
Installation
Note: When fitting the door panels, ensure that they are
in the original order.
1. Insert the intermediate panel and push it in the
direction of the arrow until it is fitted in the frame. The
arrow on the intermediate panel must line up with the
arrow on the frame (Fig. !).
2. Push the intermediate panel downwards in the ‚
area, insert the ƒ holder at an angle and push down
until it locks into place (Fig. ").
The holder is inserted (Fig. #).
I
2
1
E
D
1
E
D
2
To Next Page
Loading...
Need help?
General
