en Troubleshooting
50
Fault Cause Troubleshooting
All LEDs lit up or flashing. Electronics have detected a
fault.
1. Press the main switch button for ap-
prox. 4seconds.
→"Controls", Page15
The appliance is reset and restar-
ted.
2. If the problem occurs again:
‒ Switch off the appliance.
‒ Pull out the mains plug or
switch off the fuse in the fuse
box.
‒ Wait at least 2minutes.
‒ Switch on the fuse in the fuse
box or insert the mains plug.
‒ Switch the appliance on.
3. If the problem occurs again:
‒ Contact customer service.
→"Customer Service",
Page53
Mechanical damage
Fault Cause Troubleshooting
Appliance door cannot be
closed.
Door lock has been activ-
ated.
▶ Close the appliance door with
greater force.
Door cannot be closed due
to installation method.
▶ Check whether the appliance has
been installed properly.
When closed, the appliance door,
its decor or attached parts should
not knock against adjacent cabin-
ets or the worktop.
Lid on the detergent dis-
penser cannot be closed.
Detergent dispenser or lid
are blocked by sticky deter-
gent residue.
▶ Remove detergent residue.
Noise
Fault Cause Troubleshooting
Filling valves making knock-
ing noises.
Caused by the domestic in-
stallation. No appliance fault
present. Does not affect
functioning of the appliance.
▶ Can only be remedied in the do-
mestic installation.
Knocking or rattling noise. Spray arm is striking table-
ware.
▶ Arrange tableware so that the spray
arms do not strike tableware.
To Next Page
Loading...
Need help?
General
