en Basic operation
32
a While the programme is running, a
spot of light is projected onto the
floor below the appliance door.
This light will not be visible if the
appliance is installed at eye level
with the cabinet front fitted flush.
a The programme has ended when
no indicators on the controls light
up.
a The programme has ended when
the spot of light is no longer visible
on the floor.
Notes
¡ If you want to add more tableware
while the appliance is running, do
not use the tablet collecting tray as
a handle for the top basket. You
might touch the partially dissolved
tablet.
¡ You can only change a pro-
gramme when running if you can-
cel it.
→"Terminate programme",
Page32
¡ The appliance switches off auto-
matically 1minute after the end of
the programme to save energy. If
you open the appliance door im-
mediately after the programme has
ended, the appliance will switch off
after 4 seconds.
14.6 Interrupting programme
Note:When you open the appliance
door once the appliance has heated
up, leave the door slightly ajar for a
few minutes and then close it. This
will help prevent excess pressure
building up in the appliance and stop
the appliance door bursting open.
1. Open the appliance door carefully.
2. Press .
a The programme is saved and the
appliance switches off.
3. Press
to resume the pro-
gramme.
4. Close the appliance door.
14.7 Terminate programme
To end a programme early or to
switch from a programme that has
already started, you will need to can-
cel it first.
1. Open the appliance door.
2. Press
for approx.
4seconds.
3. Close the appliance door.
a The programme is cancelled and
ends after approx. 1minute.
14.8 Switching off appliance
1. Please note the information on
Safe use →Page10.
2. Press
.
Tip:If you press during the wash
cycle, the programme currently run-
ning will be interrupted. When you
switch the appliance back on, the
programme continues automatically.
To Next Page
Loading...
Need help?
General
