NETGEAR DGN2000 - Wireless Router User Manual

Installing Your Router Manually (Advanced, Mac, and Linux Users) 17
Setting Up Your Router for Internet Access
When configuring your wireless router manually, you must log in to your wireless-N modem
router to set it up initially and to make any changes to your wireless router’s settings later.
To access the router:
1.
Type http://192.168.0.1 in the address field of your browser, and then click Enter.
.
A login window similar to the one shown in Figure 12 will display.
The factory default state is reset when you press the Wireless On/Off and WPS
buttons on the side panel of router simultaneously. See “Restoring the Default
Configuration and Password” on page 36 for more information.
You can also enter either of these addresses to connect to your wireless router:
http://www.routerlogin.net or http://www.routerlogin.com.
Figure 11
Figure 12

NETGEAR DGN2000 - Wireless Router Specifications

General

Brand	NETGEAR
Model	DGN2000 - Wireless Router
Category	Wireless Router
Language	English