NETGEAR GS305Pv2 User Manual

NETGEAR, Inc.
350 East Plumeria Drive
San Jose, CA 95134, USA
NETGEAR INTERNATIONAL LTD
Floor 1, Building 3,
University Technology Centre
Curraheen Road, Cork,
T12EF21, Ireland
© NETGEAR, Inc., NETGEAR and the NETGEAR Logo
are trademarks of NETGEAR, Inc. Any non‑NETGEAR
trademarks are used for reference purposes only.
Support and Community
Visitnetgear.com/support togetyourquestionsansweredandaccessthelatest
downloads.
YoucanalsocheckoutourNETGEARCommunityforhelpfuladviceat
community.netgear.com.
Regulatory and Legal
SiceproduitestvenduauCanada,vouspouvezaccéderàcedocumenten
françaiscanadienàhttps://www.netgear.com/support/download/.
(IfthisproductissoldinCanada,youcanaccessthisdocumentinCanadian
Frenchathttps://www.netgear.com/support/download/.)
ForregulatorycomplianceinformationincludingtheEUDeclarationof
Conformity,visithttps://www.netgear.com/about/regulatory/.
Seetheregulatorycompliancedocumentbeforeconnectingthepowersupply.
ForNETGEAR’sPrivacyPolicy,visit https://www.netgear.com/about/privacy-policy.
Byusingthisdevice,youareagreeingtoNETGEAR’sTermsandConditionsat
https://www.netgear.com/about/terms-and-conditions.Ifyoudonotagree,return
thedevicetoyourplaceofpurchasewithinyourreturnperiod.
Donotusethisdeviceoutdoors.ThePoEsourceisintendedforintrabuilding
connectiononly.
PoE considerations
ThePoEandPoE+powersuppliedbytheswitchisprioritizedinascendingport
order(fromport1toport4),withatotalpowerbudgetof63WfortheGS305Pv2,
and83WfortheGS305PPswitch.Ifthepowerrequirementsfortheattached
powereddevices(PDs)exceedthetotalpowerbudgetoftheswitch,thePD
onthehighest-numberedportisdisabledtomakesurethatthePDsthatare
connectedtothehigher-priority,lower-numberedportsaresupportedrst.
PoE troubleshooting
HerearesometipsforcorrectingPoEproblemsthatmightoccur:
• IfthePoEMaxLEDisyellow,disconnectoneormorePoEdevicestoprevent
PoEoversubscription.Startbydisconnectingthedevicefromthehighest-
numberedport.
• Foreachpowereddevice(PD)thatisconnectedtotheswitch,theassociated
rightportLEDontheswitchlightssolidgreen.IftherightportLEDlights
yellow,aPoEfaultoccurredbecauseofoneoftheconditionslistedinthe
followingtable.
PoE Fault Condition Possible Solution
APoE-relatedshortcircuitoccurredontheport. Theproblemismostlikelywith
theattachedPD.Checkthe
conditionofthePDorrestart
thePDbydisconnectingand
reconnectingthePD.
ThePoEpowerdemandofthePDexceeded
themaximumlevelthattheswitchpermits.The
maximumlevelis15.4WforaPoEconnectionor
30WforaPoE+connection
ThePoEcurrentontheportexceededthe
classicationlimitofthePD.
ThePoEvoltageoftheportisoutsidetherange
thattheswitchpermits
Restarttheswitchtoseeifthe
conditionresolvesitself.
Mount the switch on a wall
Werecommendthatyouusethewall-mountscrewsthatcamewiththeswitch.
1. Locatethetwomountingholesonthebottompaneloftheswitch.
2. Markanddrilltwomountingholesinthewall.
3. Thetwomountingholesmustbe1.53in.(38.9mm)apart,center-to-center.
InsertthesuppliedanchorsintothewallandtightenthescrewswithaNo.2
Phillipsscrewdriver.
Leaveabout0.125in.(4mm)ofeachscrewprotrudingfromthewallsothat
youcaninsertthescrewsintotheholesonthebottompanel.
Note: Thescrewsare4.2mmindiameter,25mminlength.
Specications
October2021
Specication Description
Networkinterface RJ-45connectorfor1000BASE-T,100BASE-TX,or10BASE-T
Networkcable Category5(Cat5)orhigherratedEthernetcable
Ports 5total.Ports1-4canprovidePoE+;Port5isanuplinkport.
Poweradapter ModelGS305Pv2:54V@1.25ADCinput
ModelGS305PP:54V@1.66ADCinput
Powerconsumption ModelGS305Pv2:67.5Wmaximum;1.4Wstandby
ModelGS305PP:88.89Wmaximum;1.55Wstandby
PoEpowerbudget ModelGS305Pv2:30WmaximumperPoE+portwithatotal
PoEpowerbudgetof63Wfortheswitch
ModelGS305PP:30WmaximumperPoE+portwithatotal
PoEpowerbudgetof83Wfortheswitch
Dimensions(WxDxH) 6.2x4.0x1.1in.(158x101x29mm)
Weight 0.90lb(0.41kg)
Operatingtemperature 32–104°F(0–40°C)
Operatinghumidity 10%–90%relativehumidity,noncondensing

NETGEAR GS305Pv2 Specifications

General

Brand	NETGEAR
Model	GS305Pv2
Category	Switch
Language	English