Installation
ProSAFE Easy-Mount 8-Port Gigabit
Ethernet PoE+ Web Managed Switch
GS408EPP
Switch Mounting Holes
Switch rear panel
Cable Devices and Connect to Power
Check the Status
Power LED Le Port LEDs (Ports 1–8) Right PoE LEDs (Ports 1–4)
On 1000 Mbps link PoE in use
O 100 or 10 Mbps link PoE halted
Activity (blinking)
No PoE use (o)
No link (o)
PoE Max. LED
Less than 7W of PoE power is available
The PoE Max LED was active in the previous two minutes
PoE ports are working normally (o)
Internet
Access points
Non-PoE
Wall-Mount the Switch
You can mount the rear panel or the bottom of the switch to a wall. For
information about mounting the switch in a rack or on a pole, see the
hardware installation guide.
1. Place the mount on the wall and mark the wall where the two mounting
holes are.
2. Use the screws to attach the
mount to the wall.
3. Tighten the screws to secure
the mount.
4. Line up the back or the bottom
of the switch with the mount.
5. Insert the mount’s locking tab
and hook into the notches on
the switch.
6. Slide the switch into the mount
PoE Specifications
The switch can supply up to 30W PoE+ (IEEE 802.3at) to each port, with a total
maximum PoE power budget of 124W across all active PoE+ ports.
Supplied power is prioritized in ascending port order, up to the total power budget
of the device. If the power requirements for the attached devices exceed the total
power budget of the switch, the power to the device on the highest-numbered
PoE port is disabled to ensure that the devices connected to the higher-priority,
lower-numbered PoE ports are supported first.
It is important to note that although a device is listed as an 802.3at or 802.3af
PoE+/PoE-powered device, it might not require the maximum power limit that
is specified. Many devices require less, allowing all four PoE ports to be active
simultaneously, when the devices correctly report their PoE class to the switch.
Note: This product is intended for connection to PoE networks with no routing to an
outside plant.
VoIP phones
PoE
Switch bottom panel
Security cameras
PoE+
Default IP address: 192.168.0.239
Default password: password
To Next Page
Need help?
General
