Neuton CE 6 User Manual

NEUTON Trimmer - Safety & Operating Instructions 7
Chapter 3: Troubleshooting Tips
Most difficulties are easy to fix. Consult the Troubleshooting Table for common problems and their solutions. If you continue
to experience problems or need repairs beyond these minor adjustments, visit our website at www.neutonpower.com or call
Neuton Inc. Toll Free at: 1-866-NEUTON1 (638-8661) for assistance.
Always remove the Safety Key and Battery before performing any adjustments, maintenance, or repairs to your Mower.
Troubleshooting Table
PROBLEM CORRECTIVE ACTION
The Trimmer Motor
fails to start with the
Safety Key inserted,
and the Control Bar
depressed.
⇒ Check to make sure you have inserted the Trimmer/Edger all the way into the port(s).
⇒ Check to make sure that you properly inserted the Safety Key and the green Status Indicator
Light is ON.
⇒ Check to see if the white Button on the Safety Key has popped up; if it has, then depress the
Button to reset it.
⇒ Check that you installed the Battery correctly and that the Battery is fully charged. The green
Status Indicator Light should be ON. If not, replace with a fully charged Battery or recharge
the Battery.
⇒ Check to make sure the Mower/Auxiliary Switch is in the correct position.
⇒ Make sure you follow the correct starting sequence of sliding the orange Start Knob to the left
and squeezing the orange Control Bar.
The Trimmer stops
while trimming (for
reasons other than
releasing the
Control Bar).
⇒ The Battery has completely depleted its charge. Recharge the Battery fully or replace it with a
fully charged Battery.
⇒ The Trimmer was probably overloaded. If the Status Indicator Light is out, the Circuit Breaker
inside the Safety Key has tripped to protect the Motor. Reset Breaker by pushing in the white
Button in the Safety Key and restart the Trimmer.
⇒ The white Circuit Breaker Button in the Safety Key may not be pushed in fully. Reset it and try
again.
The Trimmer runs,
but the cutting
performance is
unsatisfactory, or
there is a loss of
power.
⇒ The Battery was probably not at full charge prior to Mowing. Charge the Battery, if necessary.
⇒ The grass may be too high or too thick for the cutting height. Raise the cutting height or
narrow your cutting swath and try again.
The Battery loses its
charge quickly.
⇒ The Battery was probably not at full charge prior to Trimming. Charge the Battery, if
necessary.
NOTE: You will need to charge a new Battery at least five (5) times to achieve maximum cutting time.
⇒ The grass may be too high or too thick for the cutting height. Raise the cutting height or
narrow your cutting swath and try again.
⇒ The Battery may be getting old. After some time, usually about five (5) years, you will need to
replace the Battery.

Neuton CE 6 Specifications

General

Brand	Neuton
Model	CE 6
Category	Trimmer
Language	English