Standard Keypad
Bolt Mechanism
Shared & Assigned Use Functionality
Product Guide
3
Programming Instructions
1 2 43
1
1a 1b
2
2a 2b
Add Manager Keys
Manager Keys can be registered to the locks at any time.
Go to a lock requiring additional
Manager Keys.
Press =` 55 `.
The LED will turn on.
Insert the Programming Key.
A two-tone beep will be heard.
Insert each additional Manager
Key one at a time.
A two-tone beep will be heard for
each Manager Key registered.
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn o.
Repeat above steps for each lock
or follow instructions to Express
Register Manager Keys to register
the same Manager Keys to
multiple locks.
Replace Keys
Replacement keys must be purchased and registered to the locks to prevent the lost/stolen keys from operating a lock.
To replace the Programming Key:
Note the order number (found on the lock’s rear unit).
Contact Digilock Support to purchase a replacement Programming Key.
To replace the Manager Keys:
Collect all remaining Manager Keys.
Go to any lock operated by the Manager Keys.
Press
=` 5 5 `.
Insert the Programming Key.
A two-tone beep will be heard and the LED will turn on.
Insert the Programming Key again.
Three sets of two-tone beeps will be heard and the LED will turn o. All
previously registered Manager Keys are erased.
Follow instructions to Add Manager Keys to register the remaining
Manager Keys to the locks.
To Next Page
Loading...
Need help?
General
