2
• The SENSOR is designed to detect iron-based
metal in motion.
• The SENSOR’s ability to detect iron-based
metal objects is based on the mass, velocity
and proximity of the object to the sensor.
EXAMPLE - A child’s bicycle moving at
2 mph @ 1’ from the sensor has a similar
effect as a car moving at 2 mph @ 6’ from
the sensor.
• The SENSOR must be stationary to function
properly.
Gate Opener
Control Box
Driveway
RANGE:
12 ft. radius
(max)
SENSOR:
2 ft. from Driveway (max)
and12 in. deep
Open Gate
Outside Sensor
Range
( allow 5 ft. for wiring
to Control Box)
Gate Opener
Control Box
12”
Minimum of 25 feet
SENSOR: 2 feet from
driveway edge and
1 foot in ground
Open Gate
Outside Sensor
Range
PVC conduit in ground
and up to control box
recommended
24”
1. Obtain the instruction manual for the gate opener.
2. Locate the control terminals (2) that will ONLY
OPEN the gate.
3. Verify that the above inputs when shorted
(a small wire connecting the 2 terminals) will
do all of the following:
• OPEN the gate if the gate is idle.
• STOP and then OPEN the gate if gate is closing.
• DO NOTHING if the gate is opening.
IMPORTANT
DO NOT CONNECT THE POWER
INPUT WIRES TO THE POWER
SOURCE (i.e. 12 V battery) UNTIL
INSTRUCTED TO DO SO.
Installation Overview
Wiring the Wand
BLACK
BLUE
RELAY OUTPUT
POWER INPUT = 11-30 Vdc or 8-26 Vac
RED
Braided
Ground
WAND
WIRING
TO OPEN ONLY
INPUT OF GATE
OPENER CONTROL
Normally open relay contacts, closes for 2
seconds when moving vehicle is detected.
+
–
YELLOW
To Next Page
Loading...
Need help?
General
