EN
WARNINGS:
– The product SHELKIT50 - SHELKIT75 is produced by Nice S.p.a. (TV) I.
– All technical specifications stated in this section refer to an ambient temperature of 20°C (± 5°C).
– Nice S.p.a. reserves the right to apply modifications to the product at any time when deemed necessary, while maintaining the same functionalities and intended use.
TECHNICAL SPECIFICATIONS OF PRODUCT COMPONENTS
GEARMOTORS: SHELKIT50 SHELKIT75
Technology adopted 24 V motor
Power supply 230 Vac 50/60 Hz
Maximum start-up torque 9 Nm 12 Nm
Nominal torque 6 Nm 7,5 Nm
Maximum thrust 500 N 750 N
Nominal thrust 350 N 450 N
Maximum power 200 W 280 W
Movement speed 0.07 ÷ 0.13 m/s 0.08 ÷ 0.14 m/s
Maximum continuous operation time 4 minutes
No. Cycles per hour at nominal torque (20°) 8
Ambient operating temperature -20° C ÷ +50° C
Dimensions 305 x 109 h x 130 (mm)
Weight 4 kg
Insulation class 1
Emergency power supply 2 batteries, 12V / 0.8Ah
Courtesy light 12 V / 10 W fitting BA15
STOP Input
For normally open, normally closed or constant resistance 8,2 K! contacts; in self-learning
(a variation with respect to the memorised status causes the command “STOP”).
STEP-STEP Input For normally open contacts
PHOTO input For safety devices with normally closed contacts
Radio receiver Built-in
Programmable functions
4 programmable functions (see paragraph 6.3) Self learning of type of
STOP device (NO contact, NC contact or 8,2 K! resistance)
Functions in self-learning mode
Self-learning of door opening and closing positions and calculation of deceleration
and partial open points.
Use in particularly acid or saline
No
potentially explosive atmospheres
Protection class IP 40 use indoors or in protected environments
Estimated durability (
*
) From 40.000 to 80.000 manoeuvre cycles
(
*
) Note – The estimated product durability ranges from 40.000 to 80.000 manoeuvre cycles.
To calculate the probable durability of your automation proceed as follows:
a) – evaluate the conditions of use and force levels involved on your system, for example:
• the weight and length of the garage door;
• perfect balancing of the garage door;
• maintenance conditions of the garage door hinges;
• type of leaf; Solid or with many openings;
• the presence of strong winds;
• frequency of automation use.
b) – from these values, obtain a value expressed as a percentage which, in general, defines
the greatest or smallest degree of automation wear.
c) – on the graph alongside, locate the estimated percentage (at point "b") and read the cor-
responding number of manoeuvre cycles.
100 %
75 %
50 %
25 %
0 %
40.000
50.000
60.000
70.000
80.000
TRANSMITTER FLO4R-S
DESCRIPTION DATA
Type 4-channel transmitter for radio control
Frequency 433.92 MHz
Encoding Rolling code with 52 Bit code type FLOR
Keys 4
Radiated power 100 µW
Power supply 12 Vdc with battery type 23 A
Battery lifetime
1 year, estimated on the basis of 20 commands/day of the duration of 1s at 20°C
(battery efficiency is reduced at low temperatures)
Ambient operating
-40°C ÷ 85°C
temperature
Protection class IP 40 (use in the home or protected environments)
Dimensions 72 x 40 h x 18 mm
Weight 30 g
To Next Page
Loading...
Need help?
General
