x3
3°
x5
FLOR VERY VR FLO VERY VE SMILO
Buttons 1 – 2 - 4 2 1 – 2 - 4 2 2 - 4
Power input 12Vdc Batt. 23A 6Vdc lithium batt. 12Vdc Batt. 23° 6Vdc lithium batt. 12Vdc Batt. 23A
Absorption 10mA 10mA 15mA 10mA 25mA
Frequency 433.92MHz
Working temp. -40°C ÷ + 85°C
Radiated power 100µW
Deleting all transmitters
All the memorised codes can be deleted as follows:
1. Press the receiver button and hold it down
2. Wait for the Led to light up, then wait for it to switch off
and then wait for it to flash 3 times
3. Release the button exactly during the third flash
N.B.: if the procedure was performed correctly, the Led will flash 5 times after a few moments.
Receivers
Transmitters
Table “B4” Deleting all transmitters Example
SMXI SMXIS SMXIF
Decoding Rolling code Rolling code 1024 FLO combinations
52 bit FLOR 64 bit SMILO
Transmitter compatibility FLOR, VERY VR SMILO FLO, VERY VE
Frequency 433.92MHz
Input impedance 52ohm
Outputs 4 (on connector SMXI)
Sensitivity better than 0.5µV
Working temp. -10°C ÷ + 55°CC
Technical characteristics
x5s
1s 1s 1s
x1
1. Press the button on the NEW transmitter for at least 5 seconds and then release
2. Press the button on the OLD transmitter 3 times slowly
3. Press the button on the NEW transmitter slowly and then release
N.B.: If there are other transmitters to memorise, repeat the above steps for each new transmitter
Table “B3” Remote Memorising Example
Remote memorising
It is possible to enter a new transmitter in the receiver memory
without using the keypad. A previously memorised and operational
remote control must be available. The new transmitter will “inherit”
the characteristics of the previously memorised one. Therefore, if the
first transmitter is memorised in mode I, the new one will also be
memorised in mode I and any of the buttons of the transmitter can
be pressed. If the first transmitter is memorised in mode II the new
one will also be memorised in mode II but the button activating the
required output must be pressed on the first transmitter as must the
button required to be memorised on the second. You need to read all
the instructions in advance so you can perform the operations in
sequence without interruptions. Now, with the two remote controls
(the NEW one requiring code memorisation and the OLD one that is
already memorised), position yourself within the operating range of
the radio controls (within maximum range) and carry out the
instructions listed in the table.
GB
3
To Next Page
Loading...
Need help?
General
