This manual is for use only by technical personnel qualified to carry out the installation.
No information given in this manual can be considered of any interest to the end user!
This handbook is enclosed with the SPIDER 6060, SPIDER 6065 and SPIDER 6100 units and must not be used for different products!
IMPORTANT NOTICE:
The unit described in this handbook is designed to control an electromechanical actuator for the automation of sectional doors,
counterweight overhead doors and spring overhead doors.
Any other use is considered improper and consequently forbidden by current laws.
It is our duty to remind you that you are carrying out operations on machine systems classified in the “Automatic gates and doors”
category and as such are considered particularly “hazardous”.
It is your job to make them as “Safe” as is reasonably possible!
Only qualified personnel should install and service the equipment. It is the responsibility of the installer to ensure that the
equipment is correctly and professionally installed in compliance with all relevant regulations and standards applicable in the country
of installation.
We draw your attention to the following most important European directives - it is the installers responsibility to check what other
regulations apply in the country of installation.
• EEC 89/392 (Machine Directive)
• PrEN 12453 (Safety in using motorised doors - requirements and classifications)
• PrEN 12445 (Safety in using motorised doors - testing methods)
Nice products are designed and manufactured to meet all current European standards and it is essential that the installer also installs
the equipment in accordance with all local and European requirements.
Unqualified personnel or those who do not know the standards applicable to the “Automatic gates and doors” category:
Must under no circumstances carry out installations or implement systems
Personnel who install or service the equipment without observing all the applicable standards:
Will be held responsible for any damage the system may cause!
CONTENTS:
1Introduction Page11
1.1 Description “ 11
2Installation instructions “ 11
2.1 Installation “ 12
2.2 Wiring diagram “ 12
2.3 Description of connections “ 13
2.4 Notes on connections “ 13
2.5 Installing the aerial “ 13
3Testing “ 13
3.1 Adjustments “ 14
3.2 Functioning modes “ 15
4Self-learning radio “ 16
4.1 Connecting an alternative radio receiver “ 16
5Maintenance “ 16
Technical Data “ 17
English
10
To Next Page
Loading...
Need help?
General
