ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual
2. Fill the tank with a clean water. The
clean water temperature must not
exceed 40 °C.
Make sure the solution valve under
the machine is open.
3. Fill the EcoFlex™ tank with a deter-
gent suitable for cleaning machines
(highly concentrated and low
foaming detergent).
4. Install the squeegee and fasten it
with the knob.
1a. Unplug the Battery charger cable.
Reconnect it to the machine.
1b. Disconnect the battery charger
cable from the electrical socket.
18. Clean the machine using a damp
cloth and where needed use a neu-
tral cleaning product.
16. Press the click-off button and wait
for the brush/pad holder to fall
on the floor. Remove to clean or
change brush.
17. Take the squeegee off and remove
debris. Check and clean the squeegee
blades.
19. Charge the batteries: Connect the
battery charger cable to the electri-
cal socket.
20. Park the machine with the recovery
tank cover open.
13. Empty the recovery tank with the
hose. Then empty the solution tank
with the transparent hose.
12.
Machine with Ecoflex, always end the daily
work with turning off the detergent 2 minutes
before finishing by pressing the detergent but-
ton. To rinse out detergent from the system and
brush before handling and cleaning.
10. If necessary press the extra pressure
function (hold for one second).
If necessary press the silent mode
button for extra low sound level.
11. Press the EcoFlex™ button when-
ever you temporarily need a greater
cleaning power.
14. Empty the debris tray and clean/
wash the recovery tank inside.
15. Clean the filter:
A) Close the solu tion valve under the machine.
B) Remove the transparent cover and the gasket,
then remove and clean the filter inside.
C) Reassemble the filter.
7. Lower the squeegee with the pedal.
5. Place the brush or the pad-holder
under the deck. Use the appropriate
brush to clean the floor.
6. Insert the operator key, then start
the machine by pressing the One-
Touch button. To engage the brush,
slightly press the drive paddle and
then release it.
8. Push forward the drive paddle to start
cleaning. Adjust maximum speed by
the speed regulation buttons.
9. To change the solution flow level
push the solution button and
change flow level according to the
cleaning performance and applica-
tion.
To Next Page
Need help?
General
