SC500 How To
Prepare for Use
1
This is how the machine
should look when you
enter the room.
2
Disconnect battery
charger, store onboard
charger cord and lower
the recovery tank lid.
3
Inspect and prepare to
Install proper pad or
brush under the deck.
Pad and Brush Installation REV Model
1
Install pad under deck.
Line up evenly
(do not
remove center section of
pad)
.
To remove primary
pad, slide hand between
pad and scrub-head face
.
2
Floor finish removal –
First - Install a new
primary floor pad
(red or
white only). Pre-wet spp
pad. Then install SPP pad
(
between the primary floor pad
and the floor)
.
3
Rev brush is optional. To
install align brush tabs
and scrub head then
tighten thumb screws.
Disc Pad or Brush Installation & Preparation for Use Continued
1
Install brush manually by
lifting brush into place
then slightly rotate to lock
in place.
2
Install brush automatically –
center brush or pad under
scrub head, set to minimum
speed, activate scrub
system then press motion
paddle to start scrub system.
1
Verify recovery tank is
empty, inspect ball float
and cage and inspect
debris catch cage.
2
Inspect blades for wear. If
worn, remove retaining
strap, flip or replace
blades, install squeegee.
Do not over tighten
knobs.
3
Do a walk-around
inspection.
Fill machine
with clean
water (water should
not exceed 104°F).
EcoFlex
system – add correct
detergent.
4
Turn on machine and verify
battery power. Press paddle
forward or pull for backward
motion
(adjust speed if needed).
Change steering direction by
pushing handle to left or
right. Transport to cleaning
area.
PrepareforUseContinued
www.totalwarehouse.com
www.totalwarehouse.com
To Next Page
Need help?
General
