Nilfisk-Advance SC500 How-To Guide



SC500 How To
Scrubbing
1
Familiarize yourself
with the operator
controls. Yellow Super
user access key allows
operator to adjust
settings.
2
Gray operator key
allows user to begin
cleaning without
changing/adjusting
machine settings.
3
Turn machine on.
Lower squeegee to the
floor. Press the one
touch scrub button then
press motion paddles
to activate scrubbing.
Adjustments while Scrubbing
1
Adjust water flow (as
needed)
. EcoFlex
Chemical Settings for
dilution ratio (must have
yellow super-user key)
.
2
Burst of power delivers
more water, detergent
and pressure to clean
stubborn areas.
Remaining battery
power displayed by
Battery Power
Indicator.
3
Adjust Scrub Pressure
settings to increase
scrub pressure.
Vacuum systems
settings can be
adjusted to normal,
quiet or vacuum off.
Vacuum off is used during
double-scrubbing.
1
Use settings above to
remove finish
(REV model
only).
Buffer pad must be
used between the SPP
pad and the velcro
surface face on the
scrub head (this prevents
damage to scrub head)
2
For efficient and safe
use:
3
If scrubbing is
complete, empty
solution and recovery
tank into proper drain.
Prepare machine for
storage and
maintenance.
www.totalwarehouse.com
833-868-2500
www.totalwarehouse.com
833-868-2500

Nilfisk-Advance SC500 Specifications

General

Brand	Nilfisk-Advance
Model	SC500
Category	Floor Machine
Language	English