10
5. Identify the Left and Right Base Covers (89, 90).
Slide the Left Base Cover onto the Left Upright
(84), and slide the Right Base Cover onto the
Right Upright (85).
Do not pinch the Handrail Wire (83) during
this step. With the help of a second person, hold
the handrail assembly (G) on the Left and Right
Uprights (84, 85). Attach the handrail assembly
with four 3/8" x 2 1/4" Screws (2) and four 3/8"
Star Washers (6); start all four Screws, and
then tighten them.
5
84
G
2
6
83
90
2
6
89
4. Have a second person hold the Right Upright
(85) against the Upright Base (94). Make sure
not to pinch the Upright Wire (82).
Insert two 3/8" x 2 1/4" Screws (2) with two 3/8"
Star Washers (6) into the top of the bracket on
the Right Upright (85), and partially tighten the
Screws into the Upright Base (94); do not fully
tighten the Screws yet.
Finish attaching the Right Upright (85) with
two 3/8" x 1 1/4" Screws (1) and two 3/8"
Star Washers (6); do not fully tighten the
Screws yet.
Attach the Left Upright (not shown) in the
same way. Note: There is not a wire on the left
side.
4
6
94
1
2
2
6
82
6
6
85
85
To Next Page
Need help?
General
